Project News | The LMS-Patriot Project

30 July, 2012 - 09:40 admin

'The Unknown Warrior' Acquires 'Royal Scot' Tender

The LMS-Patriot Project has acquired a second Fowler tender that was originally built for a 'Royal Scot' class loco. The ex Barry scrapyard tender, purchased from the East Lancashire Railway at Bury, will be stripped and after a thorough assessment will be considered for restoration and eventual use with 'The Unknown Warrior'.

Read more about 'The Unknown Warrior' Acquires 'Royal Scot' Tender

29 July, 2012 - 09:38 admin

Driving Wheel Axle Boxes

New driving wheel axle boxes are being made for 'The Unknown Warrior. The axle boxes from unrestored ex Barry Stanier 8F number 48518 were found to be of different dimensions to 'Patriot' axle boxes.

A 'Royal Scot' axle box pattern that was obtained from Wroughton needed too many modifications to make it suitable for use with 'The Unknown Warrior'.

A new 'Patriot' axle box pattern has been made by Master Pattern Maker Eddie Mocroft at the Boro Foundry. Six new loco driving wheel axle boxes have been cast. These are being machined before being fitted to the driving wheels to enable the rolling chassis to be assembled.

Read more about Driving Wheel Axle Boxes

1 May, 2012 - 15:04 admin

£500,000 Appeal Launched for New Boiler

Pete Waterman, pop mogul, steam enthusiast and loco owner was present at the launch of a £500,000 appeal for the boiler for 'The Unknown Warrior' on 19th May at the LNWR Heritage Loco works. The all new parallel ‘Fowler’ boiler of traditional construction with a copper firebox has been commissioned by the LMS-Patriot Project, the charitable group who are building the new Royal British Legion endorsed National Memorial Engine.

Read more about £500,000 Appeal Launched for New Boiler

20 February, 2012 - 08:38 admin

Spring Hangers and Cross Stay Blanks Made for 'The Unknown Warrior'

Twelve spring hangers have been made for 'The Unknown Warrior' with assistance from Project Director Neil Kinsey. The spring hangers were machined at Fastlok Engineering Ltd. in Nottingham and have now been taken to the Llangollen Railway Works to enable the rolling chassis to be assembled.

The blanks for the cross stays have also been manufactured.

Photos by Andrew Laws and Neil Kinsey.

Read more about Spring Hangers and Cross Stay Blanks Made for 'The Unknown Warrior'

21 December, 2011 - 08:38 admin

Dragbox Completed at Llangollen Works

The drag box for 'The Unknown Warrior' was completed during December 2009 at the Llangollen Railway Works. The steel plate was delivered to the Works in pre-cut sections where coded welder Ian Massey welded the sections together to form the new dragbox. The completed dragbox will require heat treatment off site to even out the stresses within the newly welded structure. The dragbox will then be returned to Llangollen for fitting in the frames, at the cab end of the locomotive.

The newly welded dragbox is seen in the images below, taken at Llangollen on 20th December.

Read more about Dragbox Completed at Llangollen Works